Please use this identifier to cite or link to this item: https://dspace.iiti.ac.in/handle/123456789/19532
Title: Machinability study of flame sprayed hydroxyapatite coating deposited on Ti-6AL-4V substrates
Authors: Tyagi, Lalit
Supervisors: Kazi Sabiruddin
Keywords: Mechanical Engineering
Issue Date: 26-May-2026
Publisher: Department of Mechanical Engineering, IIT Indore
Series/Report no.: MT571;
Abstract: Hydroxyapatite (HA) is a preferred coating material for orthopedic and dental implants due to its biocompatibility, osteoconductivity, and bioactivity. Surface coating technology, particularly thermal spray techniques such as flame spraying, enables the deposition of bioactive ceramic coatings on metallic implant substrates. Ti-6Al-4V alloy serves as the structural substrate owing to its high specific strength, corrosion resistance, and proven biocompatibility, though its bio-inert nature necessitates surface modification. Postdeposition machining of these coatings is essential for achieving precise dimensional accuracy and geometric features required for patient-specific implant fitment. In this work, seashell-derived HA powder was synthesized by the hydrothermal method, and commercial HA powder was also procured. Both powders were deposited on Ti-6Al-4V substrates using flame spraying at three standoff distances (70, 90, and 110 mm). The coatings were characterized for thickness (236.79–369.28 μm) and surface roughness (12.63–19.11 μm). Three sample types — bare Ti-6Al-4V alloy, HA Coating Seashell, and HA Coating Commercial — were then machined by conventional drilling and laser trepanning to investigate and compare their machinability characteristics. For conventional drilling, feed rate (0.125 to 0.5 mm/rev) and spindle speed (630 to 1800 rpm) were varied across an L9 Taguchi orthogonal array. For laser trepanning, duty cycle (20–50%), pulse frequency (500–2000 Hz), and trepanning speed (0.05–0.18 mm/s) were varied across an L9 array. Hole diameter, taper angle, and material removal rate (MRR) were measured as response variables. The main effect plots revealed that spindle speed is the dominant parameter for hole diameter and taper angle in conventional drilling, while feed rate dominates MRR.
URI: https://dspace.iiti.ac.in/handle/123456789/19532
Type of Material: Thesis_M.Tech
Appears in Collections:Department of Mechanical Engineering_ETD

Files in This Item:
File Description SizeFormat 
MT_571_Lalit_Tyagi_2402103012.pdf12.55 MBAdobe PDFView/Open


Items in DSpace are protected by copyright, with all rights reserved, unless otherwise indicated.

Altmetric Badge: